Re: [PATCH] [SCSI] qla2xxx: Handle the INTx not connected while passing through

Hi Martin,


On 7/29/26 8:25 AM, Martin K. Petersen wrote:
> On Fri, 15 May 2026 13:45:18 +0000, Shivaprasad G Bhat wrote:
> 
>> The PCI_INTERRUPT_PIN reports if the device supports the INTx.
>> However, when the device is assigned to a guest via vfio, the
>> PCI_INTERRUPT_PIN is set to 0(i.e none) if the line is not
>> connected and|or the platform cannot route the interrupt.
>>
>> In such cases, the guest PCI_INTERRUPT_PIN is 0 and the port
>> number becomes -1(255, uint8_t underflow) for qla[25|27|28]xx and
>> qla2031 devices. The flt_region_nvram is never set, and subsequently
>> the lun detection fails. Below warnings show the NVRAM configuration
>> failure.
>>
>> [...]
> 
> Applied to 7.3/scsi-queue, thanks!

Thanks for pulling the patch. Would it possible to get this fix into 7.2 
stream as well?

Regards,
Shivaprasad
</snip>