[sentinix-list] bound NIC's

I've set up Sentinix on a Compaq DL360 with dual Network Interfaces.  My intention was to use eth0 as the monitoring port and eth1 as the administration port.  Access to eth0 would not be allowed once it is on a spanned port on a Cisco 3550.

My problem here is that somehow both NIC's on the server are acting as one.  If I spann the one port on the switch (to eth0), access to both NIC's is unavailable.

Has anyone seen this before?  If so, how would I go about un-binding the two NIC's?

Thanks for any help you can offer.

Regards,
Bill O'Malley



THIS MESSAGE MAY CONTAIN INFORMATION THAT IS CONFIDENTIAL AND/OR PROTECTED BY LAW. IF THE READER OF THIS MESSAGE IS NOT THE INTENDED RECIPIENT, YOU ARE HEREBY NOTIFIED THAT ANY DISSEMINATION, DISTRIBUTION, COPYING OR COMMUNICATION OF THIS MESSAGE IS STRICTLY PROHIBITED. IF YOU HAVE RECEIVED THIS COMMUNICATION IN ERROR, PLEASE  CONTACT  THE SENDER IMMEDIATELY AND DELETE THE MESSAGE.  PLEASE NOTE THAT  ALTHOUGH WE WILL TAKE ALL COMMERCIALLY REASONABLE EFFORTS TO PREVENT VIRUSES FROM BEING TRANSMITTED FROM OUR SYSTEMS, IT IS THE RESPONSIBILITY OF THE RECIPIENT TO CHECK FOR AND PREVENT ADVERSE ACTION BY VIRUSES ON ITS OWN SYSTEMS .

_______________________________________________
SENTINIX mailing list
[email protected]
http://elevenprospect.com/mailman/listinfo/sentinix