Re: [sentinix-list] Making changes to initial Sentinix config (IE: IP address, Gateway)
Michel Blomgren <[email protected]>
| Newsgroups | gmane.linux.sentinix |
|---|---|
| Message-ID | <[email protected]> |
On Friday 09 January 2004 22:02, Will Bailey wrote: > Hello, > > The Sentinix setup instructions and the setup application work great! I > just setup on a third test server, this one being an old HP Pentium 2 (366 > MHz) server with four 4 gig drives in a RAID 5 config. However, I input > the incorrect gateway address in the setup. So, at this point I assume my > only choice is use ifconfig or manually edit a hosts file? Or, should I > rerun the Sentinix setup? Sorry for a newbie question! Simple root it and type "setup". Choose to configure your network cards from there. You should also be able to type "setup.eth". You'll have to re-run "/etc/rc.d/rc.inet1" after configuring, setup will only set it up, not forcefully configure your nets. You might also need to use the "route" command to remove the old default gw (not sure though). The _easy_ way is simply to reboot the machine after config. Michel > > Regards, > Will > > _______________________________________________ > SENTINIX mailing list > [email protected] > http://elevenprospect.com/mailman/listinfo/sentinix