IO-APIC Error
Markus Stutz <[email protected]>
| Newsgroups | gmane.linux.smp |
|---|---|
| Organization | infometis ag |
| Message-ID | <[email protected]> |
Hi, Reboot my System (SuSE OpenExchange Server 4.1) with newest Kernel-Patches produces the following errors: hm, page 000f1000 reserved twice. hm, page 000f2000 reserved twice. On node 0 totalpages: 515888 zone(0): 4096 pages. zone(1): 225280 pages. zone(2): 286512 pages. ACPI: RSDP (v000 ACPIAM ) @ 0x000fad30 ACPI: RSDT (v001 A M I OEMRSDT 04096.01025) @ 0x7df30000 ACPI: FADT (v001 A M I OEMFACP 04096.01025) @ 0x7df30200 ACPI: MADT (v001 A M I OEMAPIC 04096.01025) @ 0x7df30390 ACPI: OEMB (v001 A M I OEMBIOS 04096.01025) @ 0x7df40040 ACPI: DSDT (v001 PPVMM PPVMM912 00000.02322) @ 0x00000000 ACPI: Local APIC address 0xfee00000 ACPI: LAPIC (acpi_id[0x01] lapic_id[0x00] enabled) Processor #0 Unknown CPU [15:4] APIC version 20 ACPI: LAPIC (acpi_id[0x02] lapic_id[0x01] enabled) Processor #1 Unknown CPU [15:4] APIC version 20 ACPI: IOAPIC (id[0x02] address[0xfec00000] global_irq_base[0x0]) IOAPIC[0]: Assigned apic_id 2 IOAPIC[0]: apic_id 2, version 32, address 0xfec00000, IRQ 0-23 ACPI: INT_SRC_OVR (bus[0] irq[0x0] global_irq[0x2] polarity[0x0] trigger[0x0]) ACPI: INT_SRC_OVR (bus[0] irq[0x9] global_irq[0x9] polarity[0x1] trigger[0x3]) Using ACPI (MADT) for SMP configuration information Building zonelist for node : 0 Kernel command line: root=/dev/hda5 vga=788 Initializing CPU#0 Detected 3000.242 MHz processor. Console: colour dummy device 80x25 Calibrating delay loop... 5989.99 BogoMIPS Memory: 2026312k/2063552k available (1882k kernel code, 28532k reserved, 644k data, 184k init, 1146048k hig hmem) Dentry cache hash table entries: 262144 (order: 9, 2097152 bytes) Inode cache hash table entries: 131072 (order: 8, 1048576 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer-cache hash table entries: 131072 (order: 7, 524288 bytes) Page-cache hash table entries: 524288 (order: 9, 2097152 bytes) CPU: Trace cache: 12K uops<6>CPU: L2 cache: 1024K CPU: Physical Processor ID: 0 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: bfebfbff 00000000 00000000 00000000 CPU: Common caps: bfebfbff 00000000 00000000 00000000 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch ([email protected]) mtrr: detected mtrr type: Intel Monitor/Mwait feature present. CPU: Trace cache: 12K uops<6>CPU: L2 cache: 1024K CPU: Physical Processor ID: 0 Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: bfebfbff 00000000 00000000 00000000 CPU: Common caps: bfebfbff 00000000 00000000 00000000 CPU0: Intel(R) Pentium(R) 4 CPU 3.00GHz stepping 01 per-CPU timeslice cutoff: 2925.02 usecs. task migration cache decay timeout: 10 msecs. enabled ExtINT on CPU#0 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 Booting processor 1/1 eip 3000 Initializing CPU#1 masked ExtINT on CPU#1 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 Calibrating delay loop... 5989.99 BogoMIPS Monitor/Mwait feature present. CPU: Trace cache: 12K uops<6>CPU: L2 cache: 1024K CPU: Physical Processor ID: 0 Intel machine check reporting enabled on CPU#1. CPU: After generic, caps: bfebfbff 00000000 00000000 00000000 CPU: Common caps: bfebfbff 00000000 00000000 00000000 CPU1: Intel(R) Pentium(R) 4 CPU 3.00GHz stepping 01 Total of 2 processors activated (11979.98 BogoMIPS). cpu_sibling_map[0] = 1 cpu_sibling_map[1] = 0 ENABLING IO-APIC IRQs init IO_APIC IRQs IO-APIC (apicid-pin) 2-0, 2-16, 2-17, 2-18, 2-19, 2-20, 2-21, 2-22, 2-23 not connected. ..TIMER: vector=0x31 pin1=2 pin2=0 number of MP IRQ sources: 16. number of IO-APIC #2 registers: 24. testing the IO APIC....................... IO APIC #2...... .... register #00: 02000000 ....... : physical APIC id: 02 ....... : Delivery Type: 0 ....... : LTS : 0 .... register #01: 00178020 ....... : max redirection entries: 0017 ....... : PRQ implemented: 1 ....... : IO APIC version: 0020 .... register #02: 00178020 ....... : arbitration: 00 An unexpected IO-APIC was found. If this kernel release is less than three months old please report this to [email protected] .... IRQ redirection table: NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect: 00 000 00 1 0 0 0 0 0 0 00 01 003 03 0 0 0 0 0 1 1 39 02 003 03 0 0 0 0 0 1 1 31 03 003 03 0 0 0 0 0 1 1 41 04 003 03 0 0 0 0 0 1 1 49 05 003 03 0 0 0 0 0 1 1 51 06 003 03 0 0 0 0 0 1 1 59 07 003 03 0 0 0 0 0 1 1 61 08 003 03 0 0 0 0 0 1 1 69 09 003 03 1 1 0 0 0 1 1 71 0a 003 03 0 0 0 0 0 1 1 79 0b 003 03 0 0 0 0 0 1 1 81 0c 003 03 0 0 0 0 0 1 1 89 0d 003 03 0 0 0 0 0 1 1 91 0e 003 03 0 0 0 0 0 1 1 99 0f 003 03 0 0 0 0 0 1 1 A1 10 000 00 1 0 0 0 0 0 0 00 11 000 00 1 0 0 0 0 0 0 00 12 000 00 1 0 0 0 0 0 0 00 13 000 00 1 0 0 0 0 0 0 00 14 000 00 1 0 0 0 0 0 0 00 15 000 00 1 0 0 0 0 0 0 00 16 000 00 1 0 0 0 0 0 0 00 17 000 00 1 0 0 0 0 0 0 00 IRQ to pin mappings: IRQ0 -> 0:2 IRQ1 -> 0:1 IRQ3 -> 0:3 IRQ4 -> 0:4 IRQ5 -> 0:5 IRQ6 -> 0:6 IRQ7 -> 0:7 IRQ8 -> 0:8 IRQ9 -> 0:9 IRQ10 -> 0:10 IRQ11 -> 0:11 IRQ12 -> 0:12 IRQ13 -> 0:13 IRQ14 -> 0:14 IRQ15 -> 0:15 .................................... done. Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 3000.0507 MHz. ..... host bus clock speed is 200.0033 MHz. cpu: 0, clocks: 2000033, slice: 666677 CPU0<T0:2000032,T1:1333344,D:11,S:666677,C:2000033> cpu: 1, clocks: 2000033, slice: 666677 CPU1<T0:2000032,T1:666672,D:6,S:666677,C:2000033> - To unsubscribe from this list: send the line "unsubscribe linux-smp" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html