Re: [PATCH 20/26] ASoC: codecs: wm8903: Use guard() for mutex locks

On 23/07/2026 5:53 am, [email protected] wrote:
> From: bui duc phuc <[email protected]>
> 
> Clean up the code using guard() for mutex locks.
> Merely code refactoring, and no behavior change.
> 
> Signed-off-by: bui duc phuc <[email protected]>
> ---
>   sound/soc/codecs/wm8903.c | 9 ++++-----
>   1 file changed, 4 insertions(+), 5 deletions(-)
> 
> diff --git a/sound/soc/codecs/wm8903.c b/sound/soc/codecs/wm8903.c
> index 320d7737699d..156e1e24a388 100644
> --- a/sound/soc/codecs/wm8903.c
> +++ b/sound/soc/codecs/wm8903.c
> @@ -14,6 +14,7 @@
>   #include <linux/module.h>
>   #include <linux/moduleparam.h>
>   #include <linux/init.h>
> +#include <linux/cleanup.h>
>   #include <linux/completion.h>
>   #include <linux/delay.h>
>   #include <linux/gpio/driver.h>
> @@ -458,22 +459,20 @@ static int wm8903_put_deemph(struct snd_kcontrol *kcontrol,
>   	struct snd_soc_component *component = snd_kcontrol_chip(kcontrol);
>   	struct wm8903_priv *wm8903 = snd_soc_component_get_drvdata(component);
>   	unsigned int deemph = ucontrol->value.integer.value[0];
> -	int ret = 0;
>   
>   	if (deemph > 1)
>   		return -EINVAL;
>   
> -	mutex_lock(&wm8903->lock);
> +	guard(mutex)(&wm8903->lock);
>   	if (wm8903->deemph != deemph) {
>   		wm8903->deemph = deemph;
>   
>   		wm8903_set_deemph(component);
>   
> -		ret = 1;
> +		return 1;
>   	}
> -	mutex_unlock(&wm8903->lock);
>   
> -	return ret;
> +	return 0;
>   }
>   
>   /* ALSA can only do steps of .01dB */

Reviewed-by: Richard Fitzgerald <[email protected]>