Re: Problems with <SYS_PARTITION_DISK_sda>

Jürgen Henge-Ernst <[email protected]> Fri, 12 Apr 2002 18:17:47 +0200
Newsgroups gmane.linux.suse.alice
Organization SuSE Linux AG
Message-ID <[email protected]>
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Friday 12 April 2002 17:38, [email protected] wrote:
> Hi,
> i have a Problem with <SYS_PARTITION__REMOVE> and <SYS_PARTITION_DISK_sda>
> too.
>
> in my info file "final.sys.tcf" in the /info-directory are the following
> lines to my partitions:
>
> <SYS_REMOVE_PARTITION>
> /dev/sda 1 2 3
> </SYS_REMOVE_PARTITION>
> this lines are for remove the three old partitions on the hd : sda1=SWAP,
> sda2=/boot and sda3=/.
>
> And the next lines to create the new partitions sda1, sda2, sda3 and sda5.
> <SYS_PARTITION_DISK_sda>
> /boot 100 num=1 id=83 fsys=ext2
> SWAP 1000 num=2 id=82
> / 5000 num=3 id=83 fsys=ext3
> /home 0 num=5 id=83 fsys=ext3
> </SYS_PARTITION_DISK_sda>
>
> But when i start the automatic installation with the generated bootdisk
> (make_inst_disk final), the installation break by the step when the
> harddisk will creates the partitions. YaST1 show me the old partition
> configuration with the partitions sda1=SWAP, sda2=/boot and sda3=/.
>
> Where are the new partition configuration, the i have created whith
> <SYS_PARTITION_DISK_sda>?
a part in in the info-file on the bootdisk, another file called sda.p*
is also in the boot-disk with the data form <SYS_PARTITON_DISK_sda>


> What make the variable "<YAST_INFO>AUTO_FDISK  0/1/2" in the file
> /templates/yast.tcf.
> What number must i set that the installation runs automatic through the
> partition configuration?
1 stops the installation and waits the user to confirm the settings,
2 run without any confitmation of the user.


Greetings JÃŒrgen
- -- 
JÃŒrgen Henge-Ernst                    Phone:  +49 (0)6196/50 95 1-32
SuSE Linux AG                         Fax:    +49 (0)6196/40 96 07
Mergenthaler Allee 45-47              Mobile: +49 (0)177 /26 74 748
65760 Eschborn, Germany               EMail:  [email protected]
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: For info see http://www.gnupg.org

iD8DBQE8twirwIwzBbM848kRAqxoAKCJii2lmRX49/gHUkNNV06qUFZcjQCeK4X/
Ht1BAfp/5TUec8uCDNAzXUA=
=LuqP
-----END PGP SIGNATURE-----


-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]