problems with mylex-raid

Hi!
I have a problem with the mylex raid-controller. I've installed a system 
manually and found out, that I have the following partitions:

disk:
/dev/rd/c0d0
partitions:
/dev/rd/c0d0p1
/dev/rd/c0d0p2
and so on...

How can I tell, that the partitioner should use this partitions instead of 
/dev/hda. I tried:

<SYS_PART_c0d0> 

but this doesn't work.
Another problem. In the manual is an example (4.3):

RC_CONFIG_0 INITRD_MODULES DAC960

Is it possible to define this in the Alice-Scripts ??


Best regards

Stefan Weigel


-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]