Re: Automatic installation with another nethwork device maybe eth2 or eth3

Fabian Herschel <[email protected]> Mon, 10 Feb 2003 12:59:53 +0100

Newsgroups	gmane.linux.suse.alice
Message-ID	<[email protected]>

Menzel, Heiko wrote:

>>Hello, 
>>
>>  yesterday i tried to install a system with another networkdevice.
>>  I gave the network.tcf the parameter 
>>
>>  <NET_IP_CONFIG>
>>  eth2 etc.
>>  </NET_IP_CONFIG>
>>
>>  First part of automatic installation was running successful.
>>  But then i came to a window where i had only the possibility to choose the first eth device eth0.
>>
>>  How can i do a completly automatic installation with another networkdevice?
>>
Please also set
<NET_INST_DEV>ethX</NET_INST_DEV>

Best regards
Fabian Herschel

-- 
Fabian Herschel - Consultant - 	Enterprise Solutions
SuSE Linux AG  			Tel: 	+49-6196-50951-23
Mergenthalerallee 45-47 Fax: 	+49-6196-409-607 
D-65760 Eschborn		E-Mail: [email protected]
http://www.suse.de 		ALICE:  http://www.suse.de/~fabian



-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]