Looking for help about LinModem to install, Not Retrieved for my IBM Thinkpad T21 with 9.3 !?
Marc LE BISSONNAIS <[email protected]> Thu, 28 Jul 2005 18:29:22 +0200 (CEST)
| Newsgroups | gmane.linux.suse.alice |
|---|---|
| Message-ID | <6513802.1122568162305.JavaMail.www@wwinf1512> |
Hello dear Linux and Suse, users or experts,
I have an IBM Thinkpad T21 on which I have installed Suse Linux 9.3, and
unlucky, there was a winmodem installed on combined with an ethernet connection.
When it was only under Windows, that seems to be ok.
Now, it's not the same thing.
When I go out of my home and have to connect me on Internet through a basic
or standard phone line ... I need that there was a running modem or LinModem
to surf above Internet and retrieve informations or mails outside !
That is very important for me.
Have you already meet a similar issue or matter, or did you know what to do
in that case !?
Thanks a lot for any help and advices ...
PS : I have made some investigations resumed below
> -------------------------------------------------------
>
> "hwinfo --modem" ==> give a big result file
>
> with "hwinfo --pci" ==> I've a light file from which I have extracted the following lines:
>
> The problem is about the modem config with Hardware Class Unknown and not associated with an appli !?
>
> --------------------------------------------------------------------------------------------
> ...
>
> 14: PCI 03.0: 0200 Ethernet controller
> [Created at pci.273]
> Unique ID: ...
> SysFS ID: /devices/pci0000:00/0000:00:03.0
> SysFS BusID: 0000:00:03.0
> Hardware Class: network
> Model: "Intel EtherExpress PRO/100+ MiniPCI"
> Vendor: pci 0x8086 "Intel Corporation"
> Device: pci 0x1229 "82557/8/9 [Ethernet Pro 100]"
> SubVendor: pci 0x8086 "Intel Corporation"
> SubDevice: pci 0x2408 "EtherExpress PRO/100+ MiniPCI"
> Revision: 0x09
> Driver: "e100"
> Device File: eth0
> Memory Range: 0xe8120000-0xe8120fff (rw,non-prefetchable)
> I/O Ports: 0x1800-0x183f (rw)
> Memory Range: 0xe8100000-0xe811ffff (rw,non-prefetchable)
> Memory Range: 0x00000000-0x000fffff (ro,prefetchable,disabled)
> IRQ: 11 (9824 events)
> HW Address: 00:10:a4:84:8e:68
> Link detected: no
> Driver Info #0:
> Driver Status: e100 is active
> Driver Activation Cmd: "modprobe e100"
> Driver Info #1:
> Driver Status: eepro100 is not active
> Driver Activation Cmd: "modprobe eepro100"
> Config Status: cfg=no, avail=yes, need=no, active=unknown
>
> 15: PCI 03.1: 0700 Serial controller (16550)
> [Created at pci.273]
> Unique ID: ...
> SysFS ID: /devices/pci0000:00/0000:00:03.1
> SysFS BusID: 0000:00:03.1
> Hardware Class: unknown
> Model: "Intel Mini-PCI V.90 56k Modem"
> Vendor: pci 0x115d "Xircom"
> Device: pci 0x000c "Mini-PCI V.90 56k Modem"
> SubVendor: pci 0x8086 "Intel Corporation"
> SubDevice: pci 0x2408
> Driver: "serial"
> I/O Ports: 0x1840-0x1847 (rw)
> Memory Range: 0xe8121000-0xe8121fff (rw,non-prefetchable)
> IRQ: 11 (9824 events)
> Config Status: cfg=new, avail=yes, need=no, active=unknown
>
> ...
> --------------------------------------------------------------------------------------------
>
> These lines are they enough to decide which package or customization
> I should prepare ?
>
> Could you advice me on the right way ?
>
>
> Last new, I just arrived to configure and connect through wvdial and Kinternet,
> but the DNS connection and lookup failed to view any internet site...
>
>
> Thanks a lot for your help,
>
> Best regards,
>
> Marc LB / Paris - [email protected]
--
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]