network devices changing ...

Hi,

on new DELL R820 I'm currently trying to install SLES11SP1.
A newer version is not possible (software reasons ...).
I used some older autoinstall file, which works for old nodes. On the 
new node
the installations fails.
1) The initrd was modified (new tg3 and megariad_sas module. But both 
modules
  are not loaded automatically. I have to do this by hand.

2) When I start the installation process after loading the modules,
everything seems to be fine, but after the first boot the network devices
have changed. In in the udev rules file the eth{0,1} switched to eth{2,3}
and eth{2,3} switched to eth{0,1}. So after the first boot, no network
is available and I have to switch the udev rules (doing a rescue boot).
Therefore not everything of the autoinstall script is executed.

*) How can I check, why the modules are *not* loaded ?

*) Can I force in the autoinstall file to create the udev rules according
to the mac addresses (lowest mac adr. -> eth0; lowest mac adr.+1 ->eth1,...)

-- 
Bye,
     Peer
_________________________________________________________
Max-Planck-Institut fuer Biogeochemie
Dr. Peer-Joachim Koch
Hans-Knöll Str.10            Telefon: ++49 3641 57-6705
D-07745 Jena                 Telefax: ++49 3641 57-7705

begin:vcard
fn:Dr. Peer-Joachim Koch
n:Koch;Peer-Joachim
org;quoted-printable:MPI f=C3=BCr Biogeochemie;DVA
adr:;;Hans-Knoell-Str. 10;Jena;;07745;Germany
email;internet:[email protected]
title:Dr. 
tel;work:+49 3641 576705
tel;fax:+49 3641 577705
tel;cell:+49 177 387 5780
x-mozilla-html:FALSE
version:2.1
end:vcard