Re: Passing module parameters via pxelinux?
Per Jessen <[email protected]>
| Newsgroups | gmane.linux.suse.autoinstall |
|---|---|
| Organization | Per Jessens personal news-server |
| Message-ID | <[email protected]> |
Frank Steiner wrote: > Hi, > > SLES 11 SP3 has a problem in the hpsa module not supporting the P410i > controller found e.g. on HP ProLion ML350 G6. Novell suggest passing > the hpsa_allow_any module parameter: > http://www.novell.com/support/kb/doc.php?id=7014067 > > I fail to do that in AY. We boot via PXE and I load the needed modules > for the raid controllers e.g. with "insmod=hpsa" in te pxelinux.cfg > file. But I didn't find a way to pass the hpsa_allow_any parameter > here. Is it possible somehow? Putting hpsa_allow_any as normal kernel > parameter (just "hpsa_allow_any") did not work, neither did > "hpsa_allow_any=1" right after the insmod=hpsa. Try "hpsa.hpsa_allow_any=1". -- Per Jessen, Zürich (3.3°C) http://www.hostsuisse.com/ - dedicated server rental in Switzerland. -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]