Re: Question about network

Am 27.11.2014 um 23:10 schrieb Floris Bos:
> On 11/27/2014 10:15 PM, Achim Klausmann wrote:
>> Am 27.11.2014 um 20:52 schrieb Floris Bos:
>>> You used to be able to, but it is broken in the latest OpenSuse release:
>>> https://bugzilla.novell.com/show_bug.cgi?id=903582
>> ok, i wil try it in this way:
>>
>>          <interfaces config:type="list">
>>              <interface>
>>                  <bootproto>static</bootproto>
>>                  <device>eth0</device>
>>                  <ipaddr><192.168.1.132></ipaddr>
>> <netmask><255.255.255.0></netmask>
>
> Should be:
>
> <ipaddr>192.168.1.132</ipaddr>
> <netmask>255.255.255.0</netmask>
Oh, yeah my mistake.

>> <net-udev config:type="list">
>>              <rule>
>>                <name>eth0</name>
>>                <rule>ATTR{address}</rule>
>>                <value><?=$mac ?></value>
>>              </rule>
>>          </net-udev>
>>
>
> Put the MAC address of your NIC where <?=$mac ?> is. E.g. aa:bb:cc:dd:ee:ff
OK, you used <?=$mac ?> as a placeholder.
i will install 400 machines with 400 MAC-Adresses so i can't
put in a mac adress.

ok,i see. There is no way to get the first NIC which is
connected (plugin on the network) ues for eth0.

Not all 400 machines will be the same, some will have
2 Intel NICs and some 1 Intel and a Realtek.

So i have to choose the ask-method to set the NICs clear,
but that's not 'autmatic installation' anymore.

Best regards
Achim Klausmann

-- 

-- 
To unsubscribe, e-mail: [email protected]
To contact the owner, e-mail: [email protected]