Disabling FW during installation of SLES12

Hi list,

when doing an autoyast installation of SLES12 the firewall is active at the end of stage 2 but no interface is assigned
to any zone blocking SSH access until the firewall is stopped or the newly installed server is rebooted (we do not need
the firewall in our environment).

This is different then in SLES11 and earlier versions where at the end of stage 2 the firewall is not active.

Is there  a way to have the firewall automatically stopped at the end of Stage 2 in SLES12 as well?

Thanks in advance
Frieder



Mit freundlichen GrÌßen

Dr. Frieder Schmidt
Principal Technical Specialist
Lead Architect Infrastructure Solutions 
Micro Focus


 

Location: Nördlicher Zubringer 9-11, 40470 DÌsseldorf, Germany
Tel.: +49 (0)211 - 5631 3760
Mobile: +49 (0)173 5876 677 ( tel:01735876666 )
Fax.: +49 (0)211 - 5631 3769
e-mail: [email protected]

PLEASE NOTE: This e-mail may contain confidential and privileged material for the sole use of the intended recipient.
Any review, distribution or other use by anyone else is strictly prohibited. If you are not an intended recipient,
please contact the sender and delete all copies. Thank you.
 
Attachmate Group Germany GmbH,
GF: Felix Imendörffer, Jane Smithard, Graham Norton, HRB 202401 (AG MÌnchen) 



-- 
To unsubscribe, e-mail: [email protected]
To contact the owner, e-mail: [email protected]