Re: Change enumeration of disks

Daniel Spannbauer <[email protected]> Fri, 22 Feb 2019 13:16:38 +0100

Newsgroups	gmane.linux.suse.autoinstall
Message-ID	<[email protected]>


Am 02/22/2019 um 12:35 PM schrieb Ancor Gonzalez Sosa:
> On 2/22/19 11:38 AM, Daniel Spannbauer wrote:
>> Hello,
>>
>>
>> I try to install a system with an Adaptec Raid controller via autoyast.
>>
>> But when booting from the usb stick this usbstick gets sda, the two raid
>> arrays get sdb and sdc.
>>
>> Can I change the enumeration to get the two raid arrays to sda and sdb?
> That enumeration is performed by the kernel and there is not much you
> can do to influence it, as far as I know.
>
> But you can use the <skip_list> feature to try to influence how AutoYaST
> assigns the disks. For example, telling AutoYaST to skip disks smaller
> than 65GiB.
>
> See
> https://www.suse.com/documentation/sles-12/singlehtml/book_autoyast/book_autoyast.html#CreateProfile.Partitioning.config
>
Autoyast itself is not the problem, but some of my scripts are
failing.....they try to do some steps on the second harddisk. Bad, if a
usb drive is the first :/

Regards

Daniel



-- 
Daniel Spannbauer                         Systemadministration
marco Systemanalyse und Entwicklung GmbH  Tel   +49 8333 9233-27 Fax -11
Rechbergstr. 4-6, D 87727 Babenhausen     Mobil +49 171 4033220
http://www.marco.de/                      Email [email protected]
Geschäftsführer Martin Reuter             HRB 171775 Amtsgericht München

-- 
To unsubscribe, e-mail: [email protected]
To contact the owner, e-mail: [email protected]