Miata 433a with Adaptec 2409UW does not boot after the installation

Hi,

I got AlphaBios 5.7, using SuSE 7.1 Alpha Edition I got 
"Kernel panic: VFS: Unable to mount root fs on 08:02".

Milo (2.2.17) is on sda1 DOS partition with the kernel (2.2.19) - I was not able to get 2.4 working during installation - which was made and formatted using AlphaBios Disk utility. The installation is OK, I got the system quickly installed. But while rebooting the machine, after several error messages I got that kernel panic message.

I got a 4,5 GB IBM U2W SCSI HDD and a QUANTUM ATLAS IV 9 GB U2W SCSI HDD in the computer. Milo recognizes these and the SCSI card together with the IDE CDROM without any problem during installation.
The error messages look like: 

attempt to access beyond end of device
08:02: rw=0, want=2, limit=1
dev 08:02 blksize= 1024 blocknr=1 sector=2 size=1024 count=1
EXT2-fs: unable to read superblock

After the same for MINIX-fs, MS-DOS, UMSDOS and isofs.

I know the best way is SRM but it does not recognize my Adaptec card. Can somebody suggest me a possible solution to get my Miata working?

Vakvarju