Re: Problem with printing on HP2800 series on Leap 16.0, works on Tumbleweed

Hello,

In the Message; 

  Subject    : Problem with printing on HP2800 series on Leap 16.0, works on Tumbleweed
  Message-ID : <[email protected]>
  Date & Time: Mon, 17 Aug 2026 15:40:24 +0200

[FK] == Freek de Kruijf <[email protected]> has written:

FK>  Hi,

FK>  I have a HP 2800 series all-in-one printer connected on the my
FK>  local network.
FK>  I use hp-setup after installation of packet hplip to configure
FK>  the printer via Advanced setup using the IP address of the
FK>  printer.

FK>  I did this om Tumbleweed and Leap 16.0. It requires to load a
FK>  proprietary module, which goes OK.

FK>  I start printing a pdf file or the test file, which works on
FK>  Tumbleweed and I see messages about starting and finishing the
FK>  print job on both systems.

FK>  But no paper output when using Leap 16.0.

FK>  I tried cupsctl --debug-logging on Leap 16.0 and got a lot of log
FK>  output, but  no clue on what is wrong.
FK>  No denials in selinux and firewall configuration is the same on
FK>  both systems.

Don't these give you a clue?

        $ ls -l ~/PDF/

and,

	$ lpstat -p -d

Best Regards.

--
  Masaru Nomiya                       mail-to: nomiya @ ab.auone-net.jp

	"To hire for skills, firms will need to implement robust and
	    	intentional changes in their hiring practices  and change is
	    	hard."
	  
         -- Employers dont practice what they preach on skills-based hiring --