Citeren Florian Ehinger <[email protected]>:
> HI
>
> > > I have problems setting up my sytem. Normally I want to have german
> > > language, but since I'm living in China at the moment I also want to
> > > display simplified chinese texts properly and use sometimes chinese
> > > Inputmethods.
> >
> > Did you install all the appropriate SCIM packages? All you seem to me to
> > need is the desired chinese characters and the Chinese SCIM packages. Which
> > system do you use? On the SuSE 9.3 I use, all needed SCIM-stuff is there
> > and can be installed with the YaST software installer, simply entering
> > "SCIM" in the search field. I think it works great, you can enter Chinese
> > in any text field.
> My problem is not to use scim, this is working in most programs. My Problem
> is
> that when I don't set the RC_LC_CTYPE="zh_CN.UTF8" variable not all
> simplified chinese characters are shown. I think the system use a traditional
> chinese font. If I set the variable I have the problems described in the last
> email!
>
> Bye Flo
Hi,
Sorry for my unhelpful comment, I'm afraid I can't help you any further with
this, because I use only Korean as far as Asian fonts are concerned, and Korean
is a lot simpler than Chinese I guess.
Good luck,
Herman
--
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.