Re: No sound on my SuSE 9.1

Did you choose the right sound driver plugin for XMMS?  I know you can use OSS 
or ALSA.  Actually, I switched mine from ALSA to OSS because of the delays in 
ALSA (When I move the slider, there's a delay with ALSA, but none with OSS).

Vince


On Saturday 24 July 2004 12:26, Bogi Mouritsen wrote:
> Thanks. I tried alsaconf and it found an Intel system which i had it
> configure and at the end it played that same test.wav.
> Still using xmms to play music is not working - no sound at all. Using
> Kaffeine to show video gives loopy sound for a few seconds and then no
> more.
>
> :)Bogi
>
> Jean Marc Le Fevre wrote:
> >Le 24/07/04 20:52 « Bogi Mouritsen » <[email protected]> a écrit :
> >>Hi,
> >>
> >>I have problems getting my sound system working.
> >>YAST detects a SIS SI7012. When I test the sound board I get at looping
> >>sound that last for some seconds. If I test it again I get no sound at
> >>all. If I delete the sound board and add a new, yast detects the same
> >>sound board and I get the same result when testing the sound board
> >>(first test gives a very short looping sound for some seconds - repeated
> >>test give no sound).
> >>
> >>The system is a fairly new clean install of SuSE 9.1.
> >>
> >>Any suggestions would be much appreciated.
> >>
> >>Regards
> >>Bogi
> >
> >If it still exists, try alsaconf from console term. It is a program that
> >setup sound card with alsa (advanced linux sound system.
> >
> >Eos <[email protected]>