Re: PowerMac G5 questions
Dinar Valeev <[email protected]> Sun, 15 May 2016 12:34:36 +0200
| Newsgroups | gmane.linux.suse.ppc |
|---|---|
| Message-ID | <CADqALGQABx44BwVGB=RJCryGJcELqU1TFDQv8xA9fbkNTP0UZQ@mail.gmail.com> |
On Sun, May 15, 2016 at 12:32 PM, Dinar Valeev <[email protected]> wrote: > On Sun, May 15, 2016 at 9:10 AM, Larry Stotler <[email protected]> wrote: >> I installed an old Adaptec AIC-7892A PIC-X scsi card in my G5. >> However, I can't find the aic-7xxx module in order to load it...... >> >> Has this been depreciated? Or just not compiled for PPC64? I'm using >> one of the newer Tumbleweed 64bit isos. Just not enabled: arm64/default:CONFIG_SCSI_AIC7XXX=m armv7hl/default:# CONFIG_SCSI_AIC7XXX is not set armv7hl/lpae:# CONFIG_SCSI_AIC7XXX is not set i386/debug:CONFIG_SCSI_AIC7XXX=m i386/default:CONFIG_SCSI_AIC7XXX=m i386/pae:CONFIG_SCSI_AIC7XXX=m ppc64/debug:# CONFIG_SCSI_AIC7XXX is not set ppc64/default:# CONFIG_SCSI_AIC7XXX is not set ppc64le/debug:# CONFIG_SCSI_AIC7XXX is not set ppc64le/default:# CONFIG_SCSI_AIC7XXX is not set s390x/default:# CONFIG_SCSI_AIC7XXX is not set x86_64/debug:CONFIG_SCSI_AIC7XXX=m x86_64/default:CONFIG_SCSI_AIC7XXX=m > >> >> Thanx >> -- >> To unsubscribe, e-mail: [email protected] >> To contact the owner, e-mail: [email protected] >> -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]