Re: Re: ltsp still not working as advertised.....
john-paul drawneek <[email protected]>
| Newsgroups | gmane.linux.suse.schools.usa |
|---|---|
| Message-ID | <[email protected]> |
ok - tried the boot with debug mode from the look eth0 is not getting any dhcp details - so if the nics not configured how can it find anything? Will poke more... "CyberOrg" <[email protected]> wrote: > On Thu, Aug 14, 2008 at 6:08 PM, john-paul drawneek > <[email protected]> wrote: > >> eth2 Link encap:Ethernet HWaddr 00:14:22:72:E1:4C >> inet addr:192.168.100.1 Bcast:192.168.100.255 >> Mask:255.255.255.0 >> inet6 addr: fe80::214:22ff:fe72:e14c/64 Scope:Link >> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 >> RX packets:402346 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:401279 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:100 >> RX bytes:24555074 (23.4 Mb) TX bytes:581565649 (554.6 Mb) >> > >>> cat /etc/dhcpd.conf > > Looks ok, could you check IP fowarding is enabled on the server? yes > >>> and >>> /etc/sysconfig/dhcpd, to debug it. > > That looks perfect too. Its your auto gen code... > >> >> /etc/init.d/dhcpd start >> Starting DHCP server Internet Systems Consortium DHCP Server V3.0.6 >> Copyright 2004-2007 Internet Systems Consortium. >> All rights reserved. >> For info, please visit http://www.isc.org/sw/dhcp/ >> /usr/sbin/dhcpd: : Unknown error 1701220736 >> >> failed >> >> >> See nothing special, all pretty much default. >> > > Disabled dnsmasq before running rcdhcpd restart? yep > >> >> All I am doing is following your instructions, why should I have to list >> them back to you? >> > > To find out the solution to the problem you are having and I have > reached the limit of my capability to help you. Nice.... > > Ciao > > -J > -- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > >