RE: Booting SParc 10

Hi

Just checking but have you checked that the SCSI bus is properly terminated
and that the device addresses are not overlapping. I would then try the
elimination system and take out all but the most needed disk(s)/devices and
add them in one by one once you get SuSE installed.

Good luck

Andrew Hooper
www.andrew.hooper.dsl.pipex.com

-----Original Message-----
From: [email protected] [mailto:[email protected]]
Sent: 09 June 2003 07:20
To: [email protected]
Subject: [suse-sparc] Booting SParc 10


Hello All,

    New to list.

    I am booting disk 1. I do a text or Yast2 install. I get into the
startup,
and after the scsi disks are recognized, I get a never ending list of SCSI
interrupt errors. Any ideas?

    By the way - 2 Narrow SCSI disks, 2 Gb each and an external cartridge
type
cdrom. SMP system with 2 Ross 150 Mhz modules..


    TIA.


	Steve

--
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]