Re: Ultra 1 boot net/install: module inst_mode does not work

If all else fails, try redownloading the ISO file for first disk &
re-burning it.  Or go buy the package with a pressed CD.  This sounds too
much like an error in the ISO.  You may have gotten lucky with your other
machines.  Ultra 1 is 64 bit machine which will use 2.4 kernel, your other
machines were Sparc 32 bit machines which would've installed w/ 2.2 kernel.
Hence, the reason those installs went on without any problems.

my $0.02 (american)

----- Original Message -----
From: "Lou Picciano" <[email protected]>
To: "SuSE SPARC LIST" <[email protected]>
Sent: Thursday, June 13, 2002 3:12 PM
Subject: [suse-sparc] Ultra 1 boot net/install: module inst_mode does not
work


> Dear List-ers:
>
> Am attempting an install of v7.3 onto an Ultra 1  (happen to be doing it,
> with Matthias' help, over bootp and tftp...)
>
> All is going OK with the kernel boot, and mount of the install CD.
>
> However, install stops after selecting the timezone with the error:
>
> The module inst_mode does not work
>
> I cannot Retry or Next from this dialog with success.
>
> Has anyone seen this before??
>
> Lou
>
>
> --
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>
>
>


-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]