SPARC StorageArray problems

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hey Folks,

I am attempting to get a SPARC StorageArray 114 working on my Ultra1 (143 MHz) 
which is running SuSE for SPARC 7.3 as updated through YOU.  I can modprobe 
fc4 and soc, and this will light up the "Fibre Icon" on the StorageArray.  I 
do get a no license/taint the kernel error warning, but it loads the modules 
anyway.  When I modprobe pluto to load pluto.o, I get the following messages 
(after the no license/taint warning):

/lib/modules/2.4.14/kernel/drivers/scsi/pluto.o init_module: No such device
Hint: insmod errors can be caused by incorrect module parameters, including 
invalid IO or IRQ parameters
/lib/modules/2.4.14/kernel/drivers/scsi/pluto.o: insmod 
/lib/modules/2.4.14/kernel/drivers/scsi/pluto.o failed
/lib/modules/2.4.14/kernel/drivers/scsi/pluto.o: insmod pluto failed

I googled and found that a very similar question was asked on this list in 
February 2002, but I couldn't find if there was an answer.  Any help, 
pointers, etc. will be greatly appreciated.  I would hate to have to 
reinstall Solaris on this box.

Thanks,

John Heywood

- -- 
John Quentin Heywood
[email protected]
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.7 (GNU/Linux)

iD8DBQE9Na+sgYU8OFyQRP4RAlDXAJ4zvL7vsHh1dEahDZA/dNHLlcnP4gCeKjzo
MZxnie6sGs5x+obNWHulk+c=
=AxTI
-----END PGP SIGNATURE-----


-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]