802.1Q VLAN

Hi

I am looking at using VLANs on my Ultra 5s. I have the built in Happy Meal
which I don't think supports VLAN tagging so I have added Intel EtherExpress
PRO 100 cards which do.
I have compiled a 2.4.18 kernel with VLAN support and the eepro100
module/driver. 
I have installed the vconfig program which sets up the VLANs.

However when I run "vconfig add eth1 10" (which adds a vlan sub-interface
with tag 10) it does not work. The vconfig program runs but produces an
unknown command error.

I have also tried to compile the Intel e100 driver but I can't make it
compile on the Sparc.

Has anybody had any luck setting up VLANs? if so do you have some tips for
me.

Thanks

Andrew Hooper 



This message contains information which may be confidential and privileged.
The message is intended solely for the recipient and use by any other party
is not authorised.  If you have received the message in error, please
contact the sender immediately and delete it without forwarding or copying
it from your system.  Any views or opinions presented are solely those of
the author and do not necessarily represent those of VITAL Network Services
unless otherwise specifically stated. 



-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]