RE: PTI QLogic support?

Hi Brad,
I would take a look into /boot/vmlinuz.config. If there is a
CONFIG_SCSI_QLOGICPTI=m as is in my 2.4.19, then you have the module at
hand.
Doing a modprobe with the apropriate modulename should insert the module. If
you are successful doing this, you have to add the name of the module to the
INITRD_MODULES - string in /etc/rc.config and run mk_initrd. Then you ought
to be able to boot from the controller.
Hope this helps,
take care



Dieter


-- 
________________________________________________

HARMAN BECKER AUTOMOTIVE SYSTEMS

Dr.-Ing. Dieter Jurzitza
Manager Hardware Systems
         ESI

Industriegebiet Ittersbach
Becker-Göring Str. 16
D-76307 Karlsbad / Germany

Phone: +49 (0)7248 71-1577
Fax:   +49 (0)7248 71-1216
eMail: [email protected]
Internet: http://www.becker.de
 

> -----Original Message-----
> From: Brad Mattick [mailto:[email protected]]
> Sent: Wednesday, October 16, 2002 2:30 AM
> To: [email protected]
> Subject: [suse-sparc] PTI QLogic support?
> 
> 
> Hi,
> 
> Does anyone know if the default suse sparc 7.3 32bit smp 
> kernel (2.2.20-smp)
> has support for the PTI QLogic (ultra scsi differential) 
> controller card
> compiled in? Is anyone successfully using one of these with a 
> sun 711 6 disk
> ultra scsi enclosure?
> 
> I installed the card (x1065) in my sparc 20 today and the 
> kernel didn't
> recognize it. The card works fine in the boot prom; probe scsi and
> .attributes check out okay.
> 
> -Brad
> 
> 
> -- 
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>