TuxOnIce: No matching enabled allocator found. Resuming disabled.

Thomas Orgis <[email protected]> Mon, 30 Sep 2013 07:47:31 +0200
Newsgroups gmane.linux.swsusp.devel
Message-ID <[email protected]>
Hi,

trying TOI since a long pause, with kernel 3.10.13, using
tuxonice-for-linux-head-3.10.0-2013-07-14.patch.bz2 . I get $SUBJECT
when trying to hibernate using

sh$ echo disk > /sys/power/state
echo: write error: Device or resource busy

sh$ dmesg
[  827.652979] TuxOnIce: No matching enabled allocator found. Resuming disabled.

sh$ cat /sys/power/tuxonice/debug_info
TuxOnIce debugging info:
- TuxOnIce core  : 3.3
- Kernel Version : 3.10.13-toi
- Compiler vers. : 4.6
- Attempt number : 0
- Parameters     : 0 667648 0 1 -2 0
- Overall expected compression percentage: 0.
- Checksum method is 'md4'.
  0 pages resaved in atomic copy.
- Compressor is 'lzo'.
- Block I/O inactive.
- Swap Allocator enabled.
  Swap available for image: 0 pages.
- No I/O speed stats available.
- Extra pages    : 0 used/2000.
- Result         : No hibernation attempts so far.

I am a bit confused. I do use LVM on one dm_crypt volume group. I'm not
sure if I had TOI working with that before. I know it worked with plain
LUKS-encrypted partitions before. My swap volume actually only exists
for TOI (my setup from back when it didn't support anything else); I
activate it right before suspending and deactivate afterwards. It is
activated right now. Am I missing some new setting? I'm attaching my
kernel config to be sure, too.

This most likely is something obvious, some stupid oversight on my
part, right?


Alrighty then,

Thomas


PS: Still, the kernel upgrade doesn't help my LAN not getting a carrier
sometimes unless doing a standby cycle with the cable connected ...
damn, there were times when Linux used to get better and worked best on
Thinkpads anyway. But this is the wrong list for _that_.

_______________________________________________
TuxOnIce-devel mailing list
[email protected]
http://lists.tuxonice.net/listinfo/tuxonice-devel
linux-3.10.12.config.bz2 (application/x-bzip, 19.3 KB) - not displayed
signature.asc (application/pgp-signature, 198 B)
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.14 (GNU/Linux)

iEYEARECAAYFAlJJEHMACgkQm0xSvNRG1STnGwCgmDiQBaZ5+oHbRC44x6F9fhiQ
yosAn3UEhXHgxyFWcSI2no4FQ/do8Tr1
=Y76C
-----END PGP SIGNATURE-----