Re: 3w-9xxx driver disk

Remco Barendse <[email protected]>
Newsgroups gmane.linux.tao.general
Message-ID <[email protected]>
Thanks for the disk!

I tried it on Tao Update 2. The disk loads bnut the installer reports that 
'No appropriate drivers have been found on the disk'.

Ok, so I chose to manually install the driver, chose 3w-9xxx from the 
list. When loading the driver it displays an error on the screen
'error 2 reading header : cpio : Bad magic'

When I look `under water' it says:
modules to insert 3w-9xxx
module(s) 3w-9xxx not found

I saw that recently an extensive howto was added on the 3-ware site on 
how to build a driver disk for RHEL / Fedora Core 2.

If all else fails I'll try building a disk again.

Thanks again and best regards!
Remco

On Mon, 25 Oct 2004, Ethan James wrote:

> Remco,
>
> Try this disk out, uncompress the files to the root for a msdos formated 
> floppy disk.  Then at the boot: prompt type "linux dd".  It should ask for 
> you for the disk.  See if it detects the 3ware card (I don't have a card to 
> test it on, sorry).  It doesn't have the kernel driver for booting after 
> installation, so let me know if its able to detect the card, and if it does 
> I'll make the other drivers.
>
> -e
>
>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.