Re: umount /var is busy on shutdown

"Steve Campbell" <campbell-TtXmYh9KqR1Wk0Htik3J/[email protected]>
Newsgroups gmane.linux.tao.general
Message-ID <[email protected]>
Ivan,

I wasn't sure what LAuS really was until this morning after Googling. I did not get a chance to see if I had it installed before I finally re-installed, but after re-installing, I could not find the program by running "rpm -qa | grep LAuS". 

Since reverting back to the vanilla Update 2 install without upgrading with yum, I have not seen the 'busy' problem.

Does anyone know if LAuS is installed as a new package with the update, or what the package name is?

This could possibly be something I would like to exclude in my yum.conf.

Thanks for the reply and any other help others may offer.

Steve Campbell
  ----- Original Message ----- 
  From: Ivan Pesin 
  To: [email protected] 
  Sent: Saturday, November 13, 2004 2:57 PM
  Subject: Re: [Tao-discuss] umount /var is busy on shutdown


  Also, I have had a problem, when /var/log is a separate partition. After some investigation I found that LAuS is holding /var/log somehow, but either "fuser" nor "lsof" doesn't show any open files for /var/log. I have solved this in two ways. On servers, where I do not need LAuS, I turned it off. On servers where I do need LAuS I do not create a separate partition for /var/log.

  Daniele Paoni said the following on 11/13/2004 08:43 AM: 
On Fri, 2004-11-12 at 21:29, David L. Parsley wrote:

  Is this problem repeatable then?  Run mozilla, shut down & get '/var
busy'?  If so, try running mozilla, then as root, manually switch to
single-user (telinit S), stopping services, and using 'fuser' to see
what's keeping it busy (might want to 'man fuser').  e.g.:
/sbin/fuser -m /var
/var:                 1826  1826r  1826c  1826e  1895  1895r  1895e 
1952  1952r  1952c  1952e  1957  1957r  1957e  1959  1959r  1959e
...
The letter codes indicate how the process is making it busy.

regards,
      David

    I had the same problem some time ago, in my case there were no files
opened on /var but it was reported as busy.

I resolved the problem removing /var as a separate partition.

                        Daniele


_______________________________________________
Tao-discuss mailing list
[email protected]
http://mailman.taolinux.org/mailman/listinfo/tao-discuss
  

-- 
Ivan Pesin                              mailto:[email protected]
System administrator
N-iX Newcomp Computersysteme GmbH       http://www.n-ix.com


------------------------------------------------------------------------------


  _______________________________________________
  Tao-discuss mailing list
  [email protected]
  http://mailman.taolinux.org/mailman/listinfo/tao-discuss

_______________________________________________
Tao-discuss mailing list
[email protected]
http://mailman.taolinux.org/mailman/listinfo/tao-discuss
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.