Re: RE : Tao U3 x86_64 new install hangs?

On Fri, 24 Dec 2004, Ugo Bellavance wrote:

>
>
>> -----Message d'origine-----
>> De : Remco Barendse [mailto:[email protected]]
>> Envoyé : 24 décembre 2004 10:02
>> À : Tao-discuss
>> Objet : [Tao-discuss] Tao U3 x86_64 new install hangs?
>>
>>
>> Hi list!
>>
>> I am trying to install Tao x86_64 U3 on a new box with an MSI
>> K8N Neo2
>> motherboard (which has nForce 3 chipset).
>>
>> The x86 version of Tao boots all the way up to the graphical install
>> screen (but not further because I want to install it on a 3Ware 9500
>> controller for which the driver is missing in x86).
>>
>> The x86_64 version however hangs during the initial boot up
>> (even before
>> the welcome screen appears). The system hangs immediately after the
>> presence of the two PATA controllers is reported. The x86 version
>> immediately reports the PATA devices it finds, the x86_64
>> version hangs
>> before it can report any devices.
>
> Did you verify the MD5?
> Did you check the media?

No but I am using the same DVD that I used for the installation of the box 
with the HDAMA. It's not impossible but not very likely either that the 
media has gone bad that quick.

I suspect a problem with the ide driver in the kernel of U3 x86_64.

_______________________________________________
Tao-discuss mailing list
[email protected]
http://mailman.taolinux.org/mailman/listinfo/tao-discuss