Re: Upgrading Tao remotely

On Mar 16, 2005, at 5:47 AM, Patrice Guay wrote:

> I successfully upgraded Tao1 -> Tao4 with yum and a lot of patience.
> Here is my receipe for a desktop installation:
>
> 0. Make sure you have sufficient space left on your partition. I needed
>    about 3 Gb to perform the upgrade.
> 1. Remove any kernel-module you may have installed (e.g. nvidia driver,
>    alsa-driver, ndiswrapper, etc.).
> 2. Install manually yum-2.2 (testing in tao-1.0) and
>    tao-yumconf (tao-4) with rpm.
> 3. Edit /etc/yum.repos.d/taolinux.repo and replace $releasever by "4".
> 4. Run "yum update". It takes several minutes...

I get an error.
yum update

File /usr/share/yum-cli/yummain.py", line 23, in ?
    import yum
ImportError: No module named yum.

I noticed that yum-2.2 (installed from tao-4, has python2.3 lines, and 
tao -1 has only python2.2) I can't find a link to yum-2.2 for tao 1? 
Where did you get it exactly?

-- 
Nathanael D. Noblet
Gnat Solutions
204 - 131 Gorge Road E
Victoria, BC V9A 1L1

T 250.385.4613
C 250.893.4613
http://www.gnat.ca/