ftape 4.x make failed

I think I may have either messed up MCONFIG by trying to answer too many
questions or messed up something in that make config process earlier
today.  I was trying to set up for a trakker hnging off parallel port and
got the latest ftape unstable driver downloaded and am using 2.2.19 for a
kernel and found no patches for 2.2 in the patches subdirectory.  What is
the minimum modifications of a new MCONFIG file I'd need to make to see if
this will compile?  I put the source path in correctly but am about to
start this whole process over again.  If it doesn't work that time, the
tape drive gets hooked to the dos box and I'll get a dvd drive replaced
with ide cdrw and leave you all alone.

Jude <[email protected]>

-
To unsubscribe from this list: send the line "unsubscribe linux-tape" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html