Re: chrootless on 18.04

Στις 22/2/19 3:50 μ.μ., ο Mark Pengelly έγραψε:
> Have I understood correctly that I can set things up in this chrootless 
> scenario so that the pfSense DHCP server can provide IP addresses for 
> the clients and the LTSP server can provide the PXE boot (tftp?) parameters?


Yes BUT you need to make sure that pfsense does NOT send a boot filename 
nor a rootpath.

/usr/lib/klibc/bin/ipconfig -n enp2s0

on the server, does a fake DHCP request; if you see rootpath/filename 
there, then you cannot use proxyDHCP.

> 
> I followed the howto as mentioned in my first post and I had an issue 
> with dnsmasq not being able to work as "port 53 already in use by 
> systemd-resolve:"

ltsp-config should have automatically configured this.
dnsmasq does show a message like that when it's being installed, but 
when you run ltsp-config, then it runs properly.

> So far I didn't edit the /etc/ltsp/dhcpd.conf file on the server at all 
> for this chrootless setup. Everything in there is wrong for my subnet 
> and architecture - Do I need to setup that file properly for the 
> chrootless scenario? If so how come no mention of that in the howto??

That file isn't used at all when one uses dnsmasq.


_____________________________________________________________________
Ltsp-discuss mailing list.   To un-subscribe, or change prefs, goto:
      https://lists.sourceforge.net/lists/listinfo/ltsp-discuss
For additional LTSP help,   try #ltsp channel on irc.freenode.net