Re: Newbie question Netgear NIC

Note- some of the newer netgears (not fa310), are NOT Tulip, and use
oddball chipsets not supported in 2.2.20 without special patches.

What model is it?

-Tom

On Fri, 21 Jun 2002, Tom Oehser wrote:

> Date: Fri, 21 Jun 2002 22:44:09 -0400 (EDT)
> From: Tom Oehser <[email protected]>
> To: Rick Compton <[email protected]>
> Cc: [email protected]
> Subject: Re: [tomsrtbt] Newbie question Netgear NIC
>
>
> The tulip driver is hard compiled into the kernel.
>
> Are you sure it isn't just an ifconfig or route problem?
>
> What does "ifconfig /dev/eth0" say?
>
> -Tom
>
> On Fri, 21 Jun 2002, Rick Compton wrote:
>
> > Date: Fri, 21 Jun 2002 14:26:59 -0700
> > From: Rick Compton <[email protected]>
> > To: [email protected]
> > Subject: [tomsrtbt] Newbie question Netgear NIC
> >
> > I have a Netgear NIC which I know works with the tulip driver. When I boot
> > with tomsrtbt no modules are loaded and the NOC appears dead. What am I
> > doing wrong? I looked everywhere including add-ons for the tulip driver
> > without luck.
> >
> > Thank you in advance.
> >
> > Rick
> >
>