Re: init HUP and static IP

Hi Tom

> Just add something like:
> 
> ifconfig eth0 1234.1234.1234.1234 up
> route add default eth0
> route add default gw 2345.2345.2345.2345

But where's best to put that. Before or after the call to dhcpcd-- in rc.custom.gz?

I'd like only to set a static IP if dhcpcd-- couldn't find one.

Thanks for the quick response.

Yet another quickie. I'm trying to get a new pcmcia card to work. It needs tulip_cb.o. 
I replaced config and config.opts from add-ons and put the add-on tulip_cb.o in /lib/modules.
Then killed and restarted cardmgr. Insmod complains about unresolved symbols in tulip_cb.o.

Is that just because I'm using 2.0.96 (1st May) and add-on dated 28th April?

Thanks again

Pete