Re: Problem with software raid w. Trustix 2.2
Mike Bobkiewicz <[email protected]>
| Newsgroups | gmane.linux.trustix.general |
|---|---|
| Message-ID | <[email protected]> |
Hi Larry, Larry schrieb: > > What type of partitions on the drives? > If not partition type fd (linux software raid) that problem will occur. > Default is partition type 83 (linux). > you are right, it has an extended partition. Now I´ve changed it to primary, but doesn´t work after all. Still have to give mdadm --assemble to access the data on the raid. Greetings, Mike > Mike Bobkiewicz wrote: >> Hi, >> I?ve created a raid1 software raid with mdadm but can?t bring it to >> work automaticaly after a reboot, always have to give the "mdadm >> --assemble" command to bring it back online. The box is a Dell >> PowerEdge 1600 the system disk is attached to the onboard controller, >> the raid disks are attached to an adaptec 29160. During the boot >> process I can see that md autodect runs before the adaptec driver is >> loaded. Later during boot there is a message "Starting up RAID >> devices: md0(skipped)". >> My /etc/mdadm.conf looks like this: >> DEVICE /dev/sda1 /dev/sdb1 >> ARRAY /dev/md0 level=raid1 devices=/dev/sda1,/dev/sdb1 >> The mdadm -D -s output when the array is online >> ARRAY /dev/md0 level=raid1 num-devices=2 >> UUID=8b91a217:3fc89e01:40a627ac:8fe19432 >> devices=/dev/sda1,/dev/sdb1 >> Any ideas what I?m doing wrong? >> >> Regards, >> >> Mike >> _______________________________________________ >> tsl-discuss mailing list >> [email protected] >> http://lists.trustix.org/mailman/listinfo/tsl-discuss >> >