Re: Home Grown ActionTec Development Daughterboard
"Bruce D. Lightner" <lightner-2huV/[email protected]>
| Newsgroups | gmane.linux.uclinux.actiontec |
|---|---|
| Message-ID | <[email protected]> |
Patrick, > That would imply that I had an existing daughterboard. The most access to one > of the real boards is the pictures that have been available on the list. I'm impressed! I had assumed you had hardware in hand. > That > has actually made life a bit easier as I haven't had to worry about NDA > restrictions and such. True... > I actually went through all my junk electronics boxes > (and even some non junk ones) looking for the crystal last night. I think I > could match just about any other "common" frequency but that one. Too bad. If you lived in San Diego, I could probably suggest some places to look...like my house, in my pile of old cir. 1985 PC-AT ISA-bus serial port cards. A signal generator should work if you have one. Remember that you could lower the clock rate by powers of two and the Actiontec console baud rate will drop accordingly down from 115K baud. Also, you could wire up something like an NE-555 and adjust the frequency using a counter or oscilloscope. Or...you can wait for the postman! Bruce -- Bruce D. Lightner Lightner Engineering La Jolla, California Voice: +1-858-551-4011 FAX: +1-858-551-0777 Email: lightner-2huV/[email protected] URL: http://www.lightner.net/lightner/bruce/ __ ActionHack Mailing List - ActionHack-W7/[email protected] http://www.express.org/mailman/listinfo/actionhack http://www.embeddedlinuxinterfacing.com/wiki.php/ActiontecDualModem