Re: More Status of "Home Grown" ActionTec Development Daughterboard
Patrick McNamara <wpmcnamara-/[email protected]>
| Newsgroups | gmane.linux.uclinux.actiontec |
|---|---|
| Message-ID | <[email protected]> |
No, so far as I can tell, the Emac drivers have not been put in yet (as of uCLinux 2.4.24). I'm starting with trying to get the kernel to boot and dump it's console output to the serial port. The next step will be to get to the point where I can login via the serial console. If I get to that point, I may actually try bringing the Emac drivers forward and getting them commited to CVS, assuming the haven't already been. If nothing else, it's a resume building exercise, not to mention keeping my programming skills sharp. Patrick M Greg Boehnlein wrote: >On Thu, 11 Mar 2004, Patrick McNamara wrote: > > > >>Most of the Conexant stuff is in the 2.4.24 uCLinux kernel. However, >>much of the boot/init code has been re-written later in the 2.4 kernel >>series. The whole method for passing boot args to the kernel seems to >>have changed. I haven't really looked into it a whole lot. I just gave >>it a compile and tried to boot it. I got nothing on the console and >>stopped there. I've been to busy to go back to it since then. I have >>half a mind to look at the 2.6 uCLinux kernel and see how bad it looks. >> >> > >Have the Emac drivers for the Network card made it into CVS yet? > > > __ ActionHack Mailing List - ActionHack-W7/[email protected] http://www.express.org/mailman/listinfo/actionhack http://www.embeddedlinuxinterfacing.com/wiki.php/ActiontecDualModem