[PATCH m68knommu] Add the m54xx fec driver
Philippe De Muyter <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <[email protected]> |
Hello, I have cleaned up and updated to 3.6-rc5 my previous port of the freescale-written driver for the fast Ethernet Controller of the M547x and M548x ColdFires. It seems from comments found in Freescale sources that this uses a MultiChannel DMA controller marketed as MCD and available also in the NPC8220 also from Freescale. Therefore, I have split the submission in three parts : A generic MCD dma driver The M54xx instantiation of the MCD driver The FEC driver for M54xx I know there are still lines above 80 characters, but I feel they must be left that way. There are also parts of an unfinished netpoll interface. Feel free to test and comment. Philippe _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev