How to enable USB_ARCH_HAS_HCD for embedded target?
Steve deRosier <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <CALLGbRJcN89bFwzQ31rOLPJ-vudoKiWcZDHDDytKR=c7MGdjAA@mail.gmail.com> |
Can anyone tell me the "proper" or "accepted" way to enable CONFIG_USB_ARCH_HAS_HCD for my embedded uClinux project? I have a bus-connected c67x00 USB chip on my mcf5235 system. To get it running and make the chip-driver accessible, I hacked the linux-3.x/drivers/usb/Kconfig: config USB_ARCH_HAS_HCD boolean default y if USB_ARCH_HAS_OHCI default y if USB_ARCH_HAS_EHCI default y if USB_ARCH_HAS_XHCI default y if PCMCIA && !M32R # sl811_cs default y if ARM # SL-811 default y if NIOS2 # SL-811 default y if BLACKFIN # SL-811 default y if SUPERH # r8a66597-hcd + default y if M523x default PCI I selected the right stuff, setup the platform device in my board-specific .c files and have it running and tested. Now I want to cleanup so I can make my commits. Obviously this is a board-specific thing, not a "generic linux" thing, so what's the better way of doing this? Thanks, - Steve _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev