Re: [PATCH m68knommu] Add the m54xx fec driver
Greg Ungerer <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi Philippe, On 24/09/12 18:05, Philippe De Muyter wrote: > I have cleaned up and updated to 3.6-rc5 my previous port of the > freescale-written driver for the fast Ethernet Controller of the M547x > and M548x ColdFires. It seems from comments found in Freescale sources > that this uses a MultiChannel DMA controller marketed as MCD and available > also in the NPC8220 also from Freescale. Therefore, I have split the > submission in three parts : > A generic MCD dma driver > The M54xx instantiation of the MCD driver > The FEC driver for M54xx > > I know there are still lines above 80 characters, but I feel they must be > left that way. There are also parts of an unfinished netpoll interface. > > Feel free to test and comment. I assume the ultimate goal is to get into into the mainline kernel? (I hope so, I really want to see this working for good :-) I am responding to each patch on that basis - so I am being a bit picky on the details. The driver parts (driver/net/ethernet/freescale/*) will need to be reviewed on the netdev mailing list at some point. And really need to go via Dave Millers netdev tree. I am not sure who looks after the drivers/dma, but scripts/get_maintainer.pl gives a few suggestions. Would pay to send it to the m68k list as well. Regards Greg ------------------------------------------------------------------------ Greg Ungerer -- Principal Engineer EMAIL: [email protected] SnapGear Group, McAfee PHONE: +61 7 3435 2888 8 Gardner Close FAX: +61 7 3217 5323 Milton, QLD, 4064, Australia WEB: http://www.SnapGear.com _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev