Re: ls: can't open '.': Cannot allocate memory
Larry Baker <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <[email protected]> |
Luis, On 29 Oct 2012, at 8:32 AM, Luis Alves wrote: > DMA: 36*4kB 30*8kB 29*16kB 21*32kB 6*64kB 7*128kB 4*256kB 3*512kB > 0*1024kB 0*2048kB 0*4096kB = 5360kB The largest block of memory your system has available is 524288 (512*1024). > Allocation of length 528384 from process 94 (ls) failed The requested size is larger than that, so uClinux tries to allocate the next larger block size (1024K). There are none available. > Any sugestion? I do not know what determines how much memory ls allocates. I have similar memory allocation failures on my system. It does not appear to use a shared uclibc. I do not know (yet) how to enable building a shared uclibc or how to change the builds to use it. If the instructions are straightforward, I would like to hear from someone. > Regards, > Luis > _______________________________________________ > uClinux-dev mailing list > [email protected] > http://mailman.uclinux.org/mailman/listinfo/uclinux-dev > This message was resent by [email protected] > To unsubscribe see: > http://mailman.uclinux.org/mailman/options/uclinux-dev Larry Baker US Geological Survey 650-329-5608 [email protected] _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev