Re: ROMFS: bad initial checksum

Hi Greg,

you find the objdump below.

Regards
Christian

>>> Or is the checksum
>>> tested on a wrong value because I misconfigured an address.
>>> Does someone have a hint how to solve this or where to look for a
> solution?
>>> The bootmessages are attached for reference.
>>
>> Can you send the entire boot sequence?
>> I want to see all the load segment addresses that are earlier in the 
>> boot
> output.

Ok, this didn't have the information I was looking for after all :-( Can you
send the output of:

    m68k-linux-objdump --headers vmlinux

Not sure what your toolchain prefix is, but substitute in place of
m68k-linux-objdump for whatever the Code Sourcery name is.

m68k-uclinux-objdump --headers vmlinux

vmlinux:     file format elf32-m68k

Sections:
Idx Name          Size      VMA       LMA       File off  Algn
  0 .text         001c9f70  40020000  40020000  00002000  2**2
                  CONTENTS, ALLOC, LOAD, READONLY, CODE
  1 .rodata       00026640  401ea000  401ea000  001cc000  2**4
                  CONTENTS, ALLOC, LOAD, READONLY, DATA
  2 __ksymtab     000045d8  40210640  40210640  001f2640  2**1
                  CONTENTS, ALLOC, LOAD, READONLY, DATA
  3 __ksymtab_gpl 00002318  40214c18  40214c18  001f6c18  2**1
                  CONTENTS, ALLOC, LOAD, READONLY, DATA
  4 __kcrctab     000022ec  40216f30  40216f30  001f8f30  2**1
                  CONTENTS, ALLOC, LOAD, READONLY, DATA
  5 __kcrctab_gpl 0000118c  4021921c  4021921c  001fb21c  2**1
                  CONTENTS, ALLOC, LOAD, READONLY, DATA
  6 __ksymtab_strings 0000dfea  4021a3a8  4021a3a8  001fc3a8  2**0
                  CONTENTS, ALLOC, LOAD, READONLY, DATA
  7 __param       00000330  40228394  40228394  0020a394  2**2
                  CONTENTS, ALLOC, LOAD, READONLY, DATA
  8 __modver      0000193c  402286c4  402286c4  0020a6c4  2**1
                  CONTENTS, ALLOC, LOAD, READONLY, DATA
  9 .data         0001de40  4022a000  4022a000  0020c000  2**4
                  CONTENTS, ALLOC, LOAD, DATA
 10 .init.text    0000d57c  40248000  40248000  0022a000  2**1
                  CONTENTS, ALLOC, LOAD, READONLY, CODE
 11 .init.data    00004a84  4025557c  4025557c  0023757c  2**2
                  CONTENTS, ALLOC, LOAD, DATA
 12 .bss          0000f24c  4025a000  4025a000  0023c000  2**4
                  ALLOC
 13 .comment      00000030  00000000  00000000  0023c000  2**0
                  CONTENTS, READONLY

_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev