Re: [PATCH] enable Timer on coldfire 532x

Hi Christian,

On 16/04/13 18:57, Christian Gieseler wrote:
> This patch enables the initial Timer on coldfire 532x systems. 
> Without this, the scheduler will not be triggered and the system hangs,
> after all sequential code is executed. It should also apply on later kernel
> versions.
> Please be patient if the patch is not matching the needed pattern as this is
> my first patch. I am open for advice :-)

This one looks ok to me. I have applied it to the m68knommu git tree.

Regards
Greg


> Regards,
> Christian
> 
> Signed-off-by: Christian Gieseler <[email protected]>
> 
> --- linux-3.6.11/arch/m68k/platform/coldfire/m532x.c.orig	2013-04-16
> 10:38:16.604838828 +0200
> +++ linux-3.6.11/arch/m68k/platform/coldfire/m532x.c	2013-04-16
> 10:39:08.354700290 +0200
> @@ -119,7 +119,8 @@ static struct clk * const enable_clks[] 
>  	&__clk_0_24,	/* mcfuart.0 */
>  	&__clk_0_25,	/* mcfuart.1 */
>  	&__clk_0_26,	/* mcfuart.2 */
> -
> +	&__clk_0_28,	/* mcftmr.0 */
> +	&__clk_0_29,	/* mcftmr.1 */
>  	&__clk_0_32,	/* mcfpit.0 */
>  	&__clk_0_33,	/* mcfpit.1 */
>  	&__clk_0_37,	/* mcfeport.0 */
> @@ -135,8 +136,6 @@ static struct clk * const disable_clks[]
>  	&__clk_0_17,	/* edma */
>  	&__clk_0_22,	/* mcfi2c.0 */
>  	&__clk_0_23,	/* mcfqspi.0 */
> -	&__clk_0_28,	/* mcftmr.0 */
> -	&__clk_0_29,	/* mcftmr.1 */
>  	&__clk_0_30,	/* mcftmr.2 */
>  	&__clk_0_31,	/* mcftmr.3 */
>  	&__clk_0_34,	/* mcfpit.2 */
> 
> _______________________________________________
> uClinux-dev mailing list
> [email protected]
> http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
> This message was resent by [email protected]
> To unsubscribe see:
> http://mailman.uclinux.org/mailman/options/uclinux-dev
> 

_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev