Re: ARM7TDMI zImage booting
Plüss Tobias TA.E.1001 <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi Daniel, thanks for that tip. I'll try it later today. It seems difficult to find out what causes the crash. Because when I step through the code, many many instructions work without any problem; yesterdeay in the evening, I stepped about half an hour through the code, and *every* instruction was okay, but when I let the CPU run, it comes to the "critical point" after a short while, so it looks like the thing causing the crash is not near the beginning. ________________________________________ Von: [email protected] [[email protected]]" im Auftrag von "Daniel Glöckner [[email protected]] Gesendet: Sonntag, 28. Juli 2013 12:33 An: uClinux development list Betreff: Re: [uClinux-dev] ARM7TDMI zImage booting On Sun, Jul 28, 2013 at 09:16:15AM +0000, Plüss Tobias TA.E.1001 wrote: > So what I did so far is to just step trough the plain assembly code, > without any debug symbols, and you can imagine, it's very difficult > to get an idea what this thing is doing :-) In cases like these I tend to search for a group of instructions in the output of objdump -d to get the name of the previous label. If you are able to step through the code, could you determine which instruction causes the exception? Daniel _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev