Developing driver and test code
Eric Fowler <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <CAC_tj_opW9U4YUyHOd_Pb2VFqk13fQVGqcdH0sMD-oP5Xj-WOA@mail.gmail.com> |
I am hosted on a Fedora 20/i686 VM and am targeting ucLinux on an ARM Cortex. I will be developing a simple mock driver and some test code that will use the driver. All of this must of course run on the target, and optionally it would be nice to easily build targeting the host. I am trying to find the best build setup for the project. I can easily build the driver using Rubini's stock makefile. My problem is in building the client program. Remember, Rubini's files build on the target, so he does not have to go cross-platform. Is there a "school solution" for this problem? Basically I need to be able to specify build targets for the driver as well as the client app, and to build them cross-plat. Thanks Eric -- cc:NSA _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev