Re: coldfire M5272, linux-2.6.x

well, finally I've compiled the last 20131024 with codesourcery toolchain, but ...

I've then started from the config of the M5272C3 EVB  (that is is the more 
similar to mine),
and changed kernel execution form add 0x400.
The same I've  done before with a linux-2.4 kernel, and that work.
But when i do go 0x400 nothing happen on the console.
I've an ICDFZ 64K (P&E) and the only thing that I could see , looking the 
address of the assembler line
where the cpu is looped in the "calibrate_delay" function.

attached the config used.

did you know if the last uclinux (linux-3) version run on the M5272C3 EVB ?

thanks, for any information.


Il 10/04/2014 01:32, Greg Ungerer ha scritto:
> Hi Daniele,
>
> On 10/04/14 01:28, Daniele Ziglioli wrote:
>> I've tried to compile, without success, the last kernel linux-3.x for the EVM5272 freescale board.
>>
>> My environment:
>>      Ubuntu 10.04
>>      m68k-uclinux-tools-20101118.sh  or freescale-coldfire-2011.09-23-m68k-uclinux.bin
>>      uClinux-dist-20131024.tar.bz2
>> I've tried various  dist and compiler (codesourcery and uclinux) ... without success.
>>
>> Could you suggest me a working tested environment to get compiled a recent  (> linux-2.6.x ) kernel,
>> for that board (or a different similar one) ?
> What failed exactly?
> Can you show the compile logs?
>
> Regards
> Greg
>
>

-- 
Cordiali saluti,
*Daniele Ziglioli*
www.signal-elettronica.it <http://www.signal-elettronica.it/>

_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev