Re: qemu/m68k
Waldemar Brodkorb <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi Greg, > >Do you have a suggestion why I get a segfault after first executed > >command? Similar behaviour Thomas Petazzoni have seen, while he was > >trying to run buildroot in Qemu/m68k. See here: > >http://lists.busybox.net/pipermail/buildroot/2012-April/052585.html > > No, I haven't seen that behavior. Is it a hush problem? > Maybe try a simpler shell to see if you get the same result. Okay, it seems a problem with my uClibc version or configuration. Still investigating. But using the sash from uClinux works fine with my own kernel. > >qemu: hardware error: mcf_fec_read: Bad address 0x1c4 > > Hmmm, yeah, it does stop there. Not sure why. I will need to look > more closely at that. Did you found anything? BTW: Are Cisco devices not official supported by uClinux? I recently had the luck to find an old Cisco 1000 Series router with a M68360 Motorola CPU. I like to use it probably for some runtime testing, if I can boot Linux on it. best regards Waldemar _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev