Marvell Libertas support
Ivan Blackford <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel |
|---|---|
| Message-ID | <CAE74bC+pM65XJn7=jKSXi40sFc5fXETAfabDy9_J=2PEJK6=jQ@mail.gmail.com> |
Hi all, I'm trying to revive a very old uClinux build, someone built firmware for the 88W8510 and called it Liberated Libertas. I see some mentions of support for this device in the buildroot. Is this device fully supported under uClinux? I have the wl530g, as documented below: http://www.bitsum.com/openwiking/owbase/WL530G/#h15 My experience with embedded linux I would peg at newbie level. I'm quite familiar with embedded systems, and have built from source openwrt on a few occasions, but I have never gone deep into the buildroot and played with configuration files, patches, etc. Any help would be greatly appreciated, Ivan -- Thank-you for your time, Ivan Blackford [email protected] _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev