Re: arch/m68k/platform/coldfire/M527x.c : m527x_fec_init

Hi Ertheb,

On 24/03/15 04:18, ertheb wrote:
> Hi,
> 
> Very tiny change to avoid one warning with MCF5271. :-)

Thanks. I'll create a patch for that too.

Regards
Greg


> static void __init m527x_fec_init(void)
> {
> -    u16 par;
>     u8 v;
> 
>     /* Set multi-function pins to ethernet mode for fec0 */
> #if defined(CONFIG_M5271)
>     v = readb(MCFGPIO_PAR_FECI2C);
>     writeb(v | 0xf0, MCFGPIO_PAR_FECI2C);
> #else
> +    u16 par;
>     par = readw(MCFGPIO_PAR_FECI2C);
>     writew(par | 0xf00, MCFGPIO_PAR_FECI2C);
>     v = readb(MCFGPIO_PAR_FEC0HL);
>     writeb(v | 0xc0, MCFGPIO_PAR_FEC0HL);
> 
>     /* Set multi-function pins to ethernet mode for fec1 */
>     par = readw(MCFGPIO_PAR_FECI2C);
>     writew(par | 0xa0, MCFGPIO_PAR_FECI2C);
>     v = readb(MCFGPIO_PAR_FEC1HL);
>     writeb(v | 0xc0, MCFGPIO_PAR_FEC1HL);
> #endif
> }
> 
> ertheb.
> _______________________________________________
> uClinux-dev mailing list
> [email protected]
> http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
> This message was resent by [email protected]
> To unsubscribe see:
> http://mailman.uclinux.org/mailman/options/uclinux-dev
> 

_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev