Re: m68k compile issue with 4.0.5
Waldemar Brodkorb <[email protected]>
| Newsgroups | gmane.linux.uclinux.devel,gmane.linux.kernel |
|---|---|
| Message-ID | <[email protected]> |
Hi Greg, Greg Ungerer wrote, > > I don't have any compile (or runtime) problems with m5208evb_defconfig > on linux-4.0.5 either. That is close to what most people use with qemu. > What .config are you using? Are you sure the defconfig creates a bootable image? I still need at least two patches. http://cgit.openadk.org/cgi/cgit/openadk.git/tree/target/m68k/qemu-m68k/patches/4.0.5/qemu-coldfire.patch Without this one I get black screen. http://cgit.openadk.org/cgi/cgit/openadk.git/tree/target/m68k/qemu-m68k/patches/4.0.5/m68k-coldfire-fec.patch Without this one I get qemu: hardware error: mcf_fec_read: Bad address 0x1c4 ... Abort Networking still does not work for me after booting with the two patches applied: fec fec.0 (unnamed net_device) (uninitialized): MDIO read timeout fec: probe of fec.0 failed with error -5 Any idea? best regards Waldemar _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev